For Westies-at-watkins.org check out Watkins 2019
For Empirevwcamping.org go to NY State news on the dashboard.

Author Topic: Front Window Trim Pulling Off  (Read 2054 times)

0 Members and 1 Guest are viewing this topic.

jdbs3

  • LiMBO LURKER
  • **
  • Posts: 9
    • View Profile
Front Window Trim Pulling Off
« on: July 02, 2011, 06:06:15 PM »
Not sure how to describe this, but here goes ...

Where the driver side window winds up, there are 2 pieces of felt that the window goes between when all the way up.  The outer one is the inside part of the molding around the exterior window opening.

This felt has a rubber backing on it and was originally attached to the rest of the exterior rubber perimeter molding.  Now it has come loose and blows around/flaps when the window is down.  

It is only a matter of time until it tears off, and then the window will not fit snugly when up and will rattle.

The trim does not need to be replaced.  I tried gluing this (with something?) a while back, but it did not hold.

What type of adhesive (rubber to rubber?) will work here?

thanks
« Last Edit: December 31, 1969, 07:00:00 PM by jdbs3 »

aviles

  • BUS DRIVER
  • ***
  • Posts: 50
    • View Profile
(No subject)
« Reply #1 on: August 18, 2011, 09:42:18 AM »
have you tried the  3m adhesive for a reference check out the usually vendors but you can pick it up cheaper at any FLAPS
« Last Edit: December 31, 1969, 07:00:00 PM by aviles »


For Westies-at-watkins.org check out Watkins 2019
For Empirevwcamping.org go to NY State news on the dashboard.