For Westies-at-watkins.org check out Watkins 2019
For Empirevwcamping.org go to NY State news on the dashboard.

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - pinetreeporsche

Pages: [1]
1
Vanagon concerns / boxer water repair
« on: February 04, 2009, 06:51:21 AM »
OOPS!  Forgot to say:  its an '87- a second generation water-cooled.  About 70,000 mi on a motor that previous owner got VW to replace after an initial 50, so the bottom end, etc are fairly fresh, at 70,000.  My previous ownership of air-cooled vans has included a bearings-up rebuild, although my time is tighter now than then, so am considering whether to pay for the work.   -Pinetree  -in the VA 'burbs of DC; i'f you're nearby, do get in touch!

2
Did it bad-  had a small leak, sealed it with Barr's stop leak in warm weather, forgot to add antifreeze, and had it blow on me while warming up in the driveway on an uder-20 morning.  When I got back out to it, it had stalled, and was steaming, and had lots of water on the driveway.   Still starts and runs (I had Mobil 1 oil in it, so hope the cylinders are OK-- I'll do a compression test), but now a very bad leak-- like an open faucet, I think only on the pass. side-- where the first leak was.  Several Q's:  Can I do it with the motor in the car?  What source has the clearest instructions?  If I can do one siede from under the car, and the second side turns out to need it, is the under-the-car fix so bad that I'll wishI had pulled it to do the whole job at once?    
AND:  What have people paid to have this job commercially done by a waterboxer specialist (cylinder seal, etc-- no head or cylinder work)?
Please give a price for doing one side, if you have had that done, or for both, and tell me if it's with the motor in or dropped down.  THANKS

3
I just heard George Bossart's sad tail of lifting the heads on his waterboxer (2nd generation) and having the the walls come up above the rings.  I thought I was facing some top-end work for a small leak (refill the overflow tank after every 15 mile run) on my '87 where the wall hit the block, so I listened carefully and decided to stay out, and try Barr's Stop-Leak.  They make several price ranges, with increasing complexity for proper use (the top grade theyclaim is for dead head gasgets-- might work as well or better.).  I chose the next-to-most expensive, a copper color, and followed the instructions carefully. Had to  1)drain the antifreeze/coolant out, 2) use a flush, then 3) another rinse- out.  All involved unclamping the hose up over the spare tire (took the whole pan off for easy access) and pulling it off each time-- watching out for HOT water coming out.  And 4) refilling with the R wheels up on the ramps (slant put lots of uumph on the water coming out!).   Finally 5) refilling with water-only plus the Barrs, and running a good while.  Then draining the system again and refilling with coolant.  Lots of little pissy jobs, over and over, but I have no leak for the present!!  (About 120 K on the van, but previous owner claimed a rebuild at 50K by VW after a waranteed problem-- so maybe only 70K.   I'll add an update if the situation changes, but for now I'm delighted.  --Oh- I use it irregularly, as a 3rd car, except when running a bunch of boy scouts around or going camping-- only a couple of these per year.

Pages: [1]